OMGA T 53 370 — 14" Compound Mitre Chop Saw, 4 HP

The OMGA T 53 370 is the compound-cutting version of OMGA's heaviest mitre chop saw. Where the T 50 350 swings left and right, the T 53 370 tilts as well, so a mitre and a bevel happen in one pass instead of two setups. For crown, casing, frame stock and anything else that meets at a corner in two planes, that is the difference between a clean job and a fussy one.

Underneath it is the same machine as the T 50 350 and built to the same standard: solid cast iron base and head, a rotating table riding on roller bearings, and auto-centering positive stops at 45°, 30°, 22½°, 15° and 10° on both sides of centre, with manual locking for anything in between. The motor is belt driven and steps up to 4 HP to carry the extra work of an angled cut.

Capacity is 6 3/4" across at 90° and 4 1/8" at 45°, with a maximum depth of cut of 4 5/16" flat and 2" at 45°. Bevelled cross cut reaches 6 1/4". The 14" blade turns at 3,200 RPM. OMGA machines are built in Italy by DIERREGI S.r.l. and supported from OMGA Industries in South Bend, Indiana.

Three-phase power required. This machine is available in 208V, 230V or 460V three phase only — there is no single-phase version. Select your voltage above before ordering; the machine is built to the voltage you choose and it cannot be changed afterward. If your shop is on single-phase service you will need a phase converter to run this saw.

Key Features & Benefits

• Compound Cutting – mitre and bevel together in a single pass, up to 6 1/4" bevelled cross cut
• Cast Iron Base and Head – mass where it matters, so the machine absorbs vibration instead of putting it into the cut
• Roller-Bearing Rotating Table – smooth and repeatable through thousands of angle changes
• Auto-Centering Positive Stops – 45°, 30°, 22½°, 15° and 10° on both sides, found by feel rather than by squinting at a scale
• Manual Lock for Intermediate Angles – anything between the stops is still available
• Belt-Driven 4 HP Motor – a full horsepower over the T 50 350, to carry the angled cut
• 3 1/8" Dust Chute – connects to shop dust collection out of the box
• Built in Italy – manufactured by DIERREGI S.r.l. under the OMGA brand, sold and serviced in North America from South Bend, Indiana

Specifications

What's Included

• One OMGA T 53 370 compound mitre chop saw, built to the voltage selected above
• Machine only. A saw blade is not listed as included — contact us before you order if you need one supplied

Operation Video

OMGA have not filmed the T 53 370 on its own. The video shows the T 50 350 — the same machine, same cast iron base, same table and stops, without the tilting head. Everything you see here applies to the T 53 370; the T 53 370 adds bevel.

Shipping

This machine ships by freight from OMGA in South Bend, Indiana. Freight is quoted separately once we have your complete delivery address — we confirm the exact cost with you in writing before anything is charged.

Accessories and options for this machine are available — see OMGA accessories or call (888) 990-8016 and we will spec them with you once the machine is chosen.